Using spray adhesive or lashings of PVA as I have done here, cut a section of foam sheet of the same thickness as the spars: it should fit so close as to have delighted the builder of a hammerbeam roof.
Thursday, June 19, 2025
Re: Build #6
Taking our trusty G-clamps, set the sides of the keel broadly square and fix them to the centre-spar with five screws, using an offset so they don't clash with each other.
Re: Build #5
Attention turns now to the keel, and again prior to cutting I have posted a little tick on the clean edges, as these will be rooted to the underside of the deck and I want them to sit as true as possible.
Re: Build #4
I've trimmed the forward end and left overhangs at the rear of half the width of the jig-saw footplate, which saves measuring. This will serve to mount the rudder-post and actuator, beside supporting the boat when it is stood on end to drain off after it has been for a dip.
Do you like the rubber feet?
Re: Build #3
I'm going down the 20mm spar route because I've lots of that left over, along with some 20mm foam sheet from a discarded experiment. We don't say 'failed', do we, when we've simply been challenged?
Although the pattern on the site calls for made-to-measure 2' spars, there's nothing wrong with a little overhang because (a) it helps prevent wood from splitting during construction and (b) we'll hang on to some at the rear for reasons to be explained.
I've used four G-clamps to fix the lateral spars so that I can flip it over and apply a line of five screws (one at centre, two at either end and then two more in between).
Re: Build #2
Here's the deck jig-sawed square so as to leave a rough edge that I've marked with a 'B' to show that it will face the rear and leave everything neat up front for fixture of the motor.
Re: Build #1
Meanwhile back at the boat and hoping it's third time lucky, a final rebuild to prove the method and materials posted on the website at www.teledrone.com
And first off, marking up the pattern on the 2' by 4' sheet of 3.6mm plywood and I have gone large with the felt-tip as no-one is working to microns here.
Deck to the left and keel to the right, marked up in straight halves and a dotted line down the centre of the deck to mark the location of the spar... easy-peasy.
Subscribe to:
Posts (Atom)






